Circle Arc > Concentric to Circle Part (Temporary Objects Menu)

This command is used to create a Temporary Object as a circle arc which runs concentric to another circle arc. After identifying the other circle arc, the arc is determined by entering its radius.

If a circle arc is to be drawn while working in isometric or dimetric view, then the command Ellipse Arc > Vector - Vector must be used, because the result on the page is elliptical not circular.

Any circle part which exists independently or within other objects can be identified as a reference object. This can also be the arc of a circle segment or a circle arc within a surface.

The radius of the arc can be entered by clicking the mouse anywhere in the drawing at a point through which the arc should run.

The start and end angle as well as the arc direction are taken from the reference circle part.