Map Model to Page > Round Page Section (Manage Menu)

Using this command you can create a mapping defined by a round section within a page.

A mapping maps objects from the model space of the drawing (not assigned to any page) into another part of the drawing. It only works if it's assignment to a page, and displays only objects from model space. Using these mappings, multiple sections of a model can be placed only different pages and supplemented with further objects.

Using Drawing Settings > Screen you can determine if and how the model space and/or the pages shall be displayed. Use Drawing Settings > Output to control the output. Mappings cannot be nested.

The center point of the circle can be entered by clicking the mouse anywhere in the drawing.

The radius of the circle can be entered by clicking the mouse anywhere in the drawing at a point through which the circle should run.

After entering the section, the "Mapping Parameters" dialog appears, in which the initial mapping parameters can be entered.

The point from which the mapping is taken is chosen by clicking the mouse at any chosen point within the drawing.