Edit Command Parameters (Methods)

Most commands of Malz++Kassner CAD6 are controlled by a set of parameters that can be edited while the command is active. Some of the commands display a parameter dialog when they are selected from the menu or by any other means, some do not. This depends on whether a command usually requires a new parameter for each usage or not.

In both cases, the command's parameters may be viewed and altered by selecting the Extras > Change Parameters (+ESC) command. This command can also be called by pressing the key combination SHIFT+ESC or by clicking the command's icon in the Panel. Unless you have altered the key assignment, you can also press the 'N' key.

Typical commands that do display a parameter dialog on selection:

Typical commands that do not automatically display their parameter dialog, but have one anyway: