Map Model to Page > Aligned Rectangular Model Space Section (Manage Menu)

Using this command you can create a mapping defined by an aligned rectangular section within the model space.

A mapping maps objects from the model space of the drawing (not assigned to any page) into another part of the drawing. It only works if it's assignment to a page, and displays only objects from model space. Using these mappings, multiple sections of a model can be placed only different pages and supplemented with further objects.

Using Drawing Settings > Screen you can determine if and how the model space and/or the pages shall be displayed. Use Drawing Settings > Output to control the output. Mappings cannot be nested.

The first corner point of the rectangle can be entered by clicking the mouse at any point within the drawing.

The second corner point of the rectangle can be entered by clicking the mouse at any point within the drawing.

The third and fourth corner point of the rectangle can be entered by clicking the mouse at any point within the drawing.

After entering the section, the "Mapping Parameters" dialog appears, in which the initial mapping parameters can be entered.

The point at which the mapping is placed is chosen by clicking the mouse at any chosen point within the drawing.

The third and fourth corner points are calculated so that they lie on one line though the third point. The first edge of the rectangle will automatically be horizontally aligned on the page.