Construction Aid Beam > Angle to Line (Construct Menu)

www.CAD6.com

This command draws a Construction Aid beam which runs at a specific angle to a line of any type.

 

1.Enter angle

After choosing this command, a dialog appears into which the angle to be used can be entered.

 

2.Identify reference line

Any line in an existing object can be identified as a reference line, including a side of a rectangle or a circle segment leg.

 

After identification, a straight line appears which runs at the previously entered angle to the identified line and moves with the mouse. This line is referred to as the "Reference Straight Line".

 

3.Enter start point

The start point of the Construction Aid beam can be entered by clicking the mouse anywhere in the drawing.

 

4.Enter end point

The second point on the Construction Aid beam can be entered by clicking the mouse anywhere in the drawing. A perpendicular is dropped from this position to the reference straight line to determine the direction of the new Construction Aid beam.

 

 

CAD6studio Release 2024.0 - Copyright 2024 Malz++Kassner® GmbH