Export to > Bitmap File (*.*), Polygon (File Menu)

Using this command, a polygonal section of the drawing can be saved to a file in one the supported formats.

The start point of the polygon can be entered by clicking the mouse anywhere in the drawing.

After entering the start point, more points can be entered. The polygon begins at the start point, runs through all the subsequently-entered points and ends at the start point. These points can be entered by clicking the mouse anywhere in the drawing.

Once all desired points have been entered (at least 3), press the right mouse button to finish the command. If the Workflow Manager is active and appears, choose Finish Command in it.

The polygon can have up to 100 segments. If this limit is reached during entry, then further point entry is not allowed.

After entering the polygon, the "File Selection" dialog appears in which the file to be used can be chosen. When pressing the "Options" button in the file selection dialog, the "Export Bitmap" dialog appears in which the bitmap creation parameters can be edited.

The data are created as if for printing, i.e. the output pen and layer properties are used.