Line > Center Cross (Draw Menu)

This command draws two lines, one horizontal and one vertical. Their midpoints cross at the given point.

This command is particularly useful to draw center crosses for drilled holes and other construction elements.

The center of the cross is determined by a point entered by clicking with the mouse anywhere within the drawing.

The length of both lines is determined by a point which lies on the outline of a circle tangent to both lines. This point can be entered by clicking with the mouse anywhere within the drawing. The lines are always limited by a circle, even if an ellipse was identified beforehand.

The two lines are assigned to the current layer. You also see a reference to the currently active pen.