Ellipse > Rectangular, Rotated (Draw Menu)

www.CAD6.com

This command draws a rotated rectangular ellipse. "Rectangular" means here that both of the ellipse's half-axes are at right angles to one another.

 

1.Enter center point

The center point of the ellipse can be entered with the mouse by clicking at any point in the drawing.

 

2.Enter point on frame

The point on the frame surrounding the ellipse can be entered with the mouse by clicking anywhere in the drawing.

 

3.Enter angle

The ellipse rotation angle can be entered with the mouse by clicking anywhere in the drawing. The position of this point relative to the center point determines the rotation angle.

 

A rectangular ellipse is stored internally as a distorted ellipse. They can be further rotated or distorted later.

 

The ellipse is assigned to the current layer. It also contains a reference to the current pen.

 

CAD6studio Release 2024.0 - Copyright 2024 Malz++Kassner® GmbH