Circle > Incircle (Draw Menu) |
www.CAD6.com |
This command draws a circle. The circle is calculated from the positions of the corner points of a triangle which it should lie within.
If the sides of the triangle are known, then the command Circle > Object - Object - Object can be used instead.
If a circle is to be drawn while working in isometric or dimetric views, this must be done with the command Ellipse > Vector - Vector because the result on the page is not circular but elliptical.
The first corner point of the triangle can be entered by clicking the mouse anywhere within the drawing.
The second corner point of the triangle can be entered by clicking the mouse anywhere within the drawing.
The first corner point of the triangle can be entered by clicking the mouse anywhere within the drawing.
The circle is assigned to the current layer. In addition, it contains a reference to the current pen.
|
CAD6studio Release 2024.0 - Copyright 2024 Malz++Kassner® GmbH